Compliance Test Plans and Traceability: Inputs and Outputs

Inputs and outputs contract

Inputs and Outputs for Compliance Test Plans and Traceability focuses on spec-clause coverage percentage and audit-ready trace completeness. The purpose is to turn memory observations into mechanism-backed actions with explicit owners and release-safe validation.

Use this contract for architecture, controller firmware, PHY, and validation handoffs. Missing inputs create expensive late-stage rework and inconclusive debug loops.

INPUTS
  - workload distribution and QoS target
  - firmware revision, controller policy profile, timing registers
  - data-rate / voltage / temperature operating state
  - training snapshot and reliability policy status

OUTPUTS
  - bottleneck classification with command-level evidence
  - owner-signed mitigation proposal
  - before/after trend for latency, bandwidth, and reliability
  - regression matrix with rollback triggers

Ownership split

MEMORY OWNERSHIP LAYERS - Compliance Test Plans and Traceability

artifact area     owner
----------------  ----------------------------
architecture    VIP architect
controller FW   verification lead
verification    protocol owner
silicon bringup compliance engineer

Rule: every signoff metric has a named accountable owner.

VIP deep dive

Compliance test plans, plugfest-style interoperability, spec-version matrices, and waiver/deviation governance for customer-ready VIP.

Concept diagram

VIP SECTION - Compliance Suites & Spec Alignment

testcase -> agents -> checkers -> coverage -> evidence

Metric graph

checker noise vs real violations trend

Reports and artifacts

• checker hit report

• coverage closure sheet

• compliance trace matrix

• regression health snapshot

Mini case study

A profile drift caused false checker storms until configuration hashes were locked in CI.

Debug branches

• Reproduce with locked seed and profile

• Isolate checker vs scoreboard vs DUT paths

• Map failure to spec clause and owner

Senior review question

Ask: which latency, bandwidth, and reliability evidence proves this VIP topic is closed under real traffic?

Key takeaways

• Always tie controller and PHY counter shifts to application latency and throughput outcomes.

• Lock firmware timing profile, thermal condition, and DIMM state before comparing VIP captures.

Common pitfalls

• Chasing peak bandwidth while ignoring p99 latency and fairness tails.

• Changing timing guardbands without separating SI noise from scheduling issues.

• Declaring closure without reliability gates, fault injection, and regression replay.

VIP atlas notes

Compliance Test Plans and Traceability should be read as an end-to-end VIP behavior, not as a single block definition. Production compliance closure reflects interactions between agents, checkers, coverage, and customer evidence before tapeout or IP release claims.

Compliance test plans tie every spec requirement to tests, checkers, and coverage bins with bidirectional traceability. Plans must survive spec updates through versioned matrices and change-impact analysis before release qualification. VIP inefficiency is multiplicative: one weak checker enable, one hollow coverage bin, or one non-reproducible failure repeated across regressions can dominate signoff risk.