AXI Channels & Transfers: Reports & Metrics

Reports and metrics

Reports & Metrics for AXI Channels & Transfers focuses on read/write throughput, outstanding transaction depth, response error rate. The goal is to connect the observable symptom to protocol mechanism, ownership, and regression risk.

The job of a report is to turn read/write throughput, outstanding transaction depth, response error rate into a decision. A single average number is almost never enough; you need the distribution, the traffic class breakdown, and a clear gap between legal maximum and product target.

Metric movement

METRIC GRAPH — read/write throughput, outstanding transaction depth, response error rate

throughput / success
  ^
  |                         target
  |                       - - - - - - -
  |                  o after bounded fix
  |              o
  |         o baseline
  |    o failing run
  +--------------------------------------> experiment
    config A     isolated root cause     accepted change

Readout:
  - compare identical payload, clock, reset, traffic seed, and firmware setup
  - separate headline bandwidth from useful payload bandwidth
  - explain why the protocol mechanism moved the metric

Latency distribution

LATENCY HISTOGRAM — AXI Channels & Transfers

count
  |               ███
  |             ███████
  |          █████████████
  |        █████████████████        <- long tail = the real complaint
  |      ████████████████████████████
  +------------------------------------> latency
   p50      p90    p95       p99  (watch p99, not the average)

Average hides the tail; product pain lives at p95/p99.

• Track read/write throughput, outstanding transaction depth, response error rate by traffic class, payload size, and clock/reset mode.

• Report p50/p95/p99 latency when user-visible stalls matter.

• Include legal maximums and product targets; they are not the same thing.

• Always store the metric next to the artifact that produced it.

Protocol deep dive

AMBA is the on-chip lingua franca: APB for control, AHB for legacy bursts, AXI for high-performance coherent fabrics.

Concept diagram

AMBA INTEGRATION MAP

CPU --AXI--> NIC --AXI--> SRAM
  |              |
  +--AXI-Lite--> peripherals (GPIO, timers)
  +--AXI-Stream-> video pipe

Every bridge is a contract rewrite: width, ID, burst, cache attrs.

Metric graph

AXI CHANNEL ACTIVITY (mixed traffic)

AW+W     ████████████
AR       ████████████████
R        ██████████████
B        ████████

Read-heavy phase: AR/R dominate; write resp may look idle while system is healthy.

Metrics and artifacts to collect

• AR/AW/R/B channel utilization

• write resp latency

• read OSTD depth

• SLVERR/DECERR count

• bridge hang log

Mini case study

Write burst hung because W beats arrived before AW for a narrow bridge that reordered channels. VIP flagged nothing until full-system traffic interleaved reads and writes.

Debug branches

• Hung write: verify AW/W ordering and wlast alignment.

• Hung read: check arready stall and rlast per ID.

• Decode errors: address map vs interconnect route table.

Senior review question

Ask: what is the first transaction that deviates, and which spec rule does it test?

Key takeaways

• Connect every protocol claim to a transaction identity and measurable metric.

• Store the artifact (waveform, log, counter) next to every signoff decision.

Common pitfalls

• Debugging timeouts without finding the first bad transaction.

• Quoting peak bus width without payload efficiency and retry overhead.

• Treating VIP compliance as a substitute for system integration replay.

How to read the numbers

read/write throughput, outstanding transaction depth, response error rate must be split by traffic class, payload size, and reset mode.