Inputs and outputs contract

Inputs & Outputs for AXI-Lite & AXI-Stream focuses on register response latency, stream bubble rate, packet boundary errors. The goal is to connect the observable symptom to protocol mechanism, ownership, and regression risk.

Treat these as a signed interface contract. Ambiguity here is the single biggest source of wasted integration weeks, because two teams debug against different assumptions.

INPUTS
  - protocol spec revision and feature subset
  - clock/reset assumptions
  - address map, ID/tag width, ordering attributes
  - traffic class, QoS, firmware register settings

OUTPUTS
  - legal transaction trace
  - integration waiver list
  - VIP/compliance report
  - owner-signed debug or signoff note

Transaction sequence

SEQUENCE — AXI-Lite & AXI-Stream

  initiator            interconnect/PHY            target
      |  request (id) ------->  |                     |
      |                         |  forward ----------> |
      |                         |                     | work
      |                         |  <---- response ---- |
      |  <----- complete ------ |                     |
      |
   metric captured here: register response latency, stream bubble rate, packet boundary errors

Ownership map

OWNERSHIP MAP — AXI-Lite & AXI-Stream

evidence type        owner who reads it
-----------------    ---------------------------
waveform/RTL        IP owner
spec/VIP            verification owner
firmware/system     driver owner

Rule: every metric must have a named owner before a review starts.

Protocol deep dive

AMBA is the on-chip lingua franca: APB for control, AHB for legacy bursts, AXI for high-performance coherent fabrics.

Concept diagram

AMBA INTEGRATION MAP

CPU --AXI--> NIC --AXI--> SRAM
  |              |
  +--AXI-Lite--> peripherals (GPIO, timers)
  +--AXI-Stream-> video pipe

Every bridge is a contract rewrite: width, ID, burst, cache attrs.

Metric graph

AXI CHANNEL ACTIVITY (mixed traffic)

AW+W     ████████████
AR       ████████████████
R        ██████████████
B        ████████

Read-heavy phase: AR/R dominate; write resp may look idle while system is healthy.

Metrics and artifacts to collect

• AR/AW/R/B channel utilization

• write resp latency

• read OSTD depth

• SLVERR/DECERR count

• bridge hang log

Mini case study

Write burst hung because W beats arrived before AW for a narrow bridge that reordered channels. VIP flagged nothing until full-system traffic interleaved reads and writes.

Debug branches

• Hung write: verify AW/W ordering and wlast alignment.

• Hung read: check arready stall and rlast per ID.

• Decode errors: address map vs interconnect route table.

Senior review question

Ask: what is the first transaction that deviates, and which spec rule does it test?

Key takeaways

• Connect every protocol claim to a transaction identity and measurable metric.

• Store the artifact (waveform, log, counter) next to every signoff decision.

Common pitfalls

• Debugging timeouts without finding the first bad transaction.

• Quoting peak bus width without payload efficiency and retry overhead.

• Treating VIP compliance as a substitute for system integration replay.

Principal review addendum

Re-read AXI-Lite & AXI-Stream against one concrete product workload, not a synthetic directed test.

AXI-Lite removes bursts for control paths while AXI-Stream moves ordered data without addresses.