Inputs and outputs contract

Inputs & Outputs for Clocking for Test focuses on test clock reachability, pulse legality, scan shift/capture violations. The goal is to convert metric movement into mechanism, owner, and release decision.

Treat these as a release contract. Ambiguity here creates expensive debug loops because teams optimize against different assumptions.

INPUTS
  - scan/ATPG architecture and constraints
  - fault model and quality target policy
  - pattern generation config + tester limits
  - timing/power/physical assumptions

OUTPUTS
  - quality metrics and closure status
  - signed artifacts and owner approvals
  - diagnosis evidence for residual risk
  - release, waiver, or escalation decision

Flow sequence

DFT FLOW - Clocking for Test

scan insertion -> chain stitch -> compression map -> ATPG -> tester apply -> diagnosis
      |                |                |            |             |
 controllability   shift balance    channel use   coverage     silicon correlation

Primary metric: test clock reachability, pulse legality, scan shift/capture violations

Ownership map

OWNERSHIP MAP - Clocking for Test

artifact              owner
----------------      -----------------
architecture/report DFT owner
constraints/setup   CTS owner
physical/test       STA owner

Name an owner for each failing metric cluster.

DFT deep dive

Scan architecture quality determines whether ATPG can control and observe real silicon state.

Concept diagram

SCAN INSERTION FLOW

scan-ready RTL -> scan replacement -> stitch chains -> DRC -> ATPG handoff

Metric graph

CHAIN BALANCE

chain length spread
low spread   = better shift time
high spread  = routing + hold risk

Reports and artifacts

• scan insertion summary

• chain balance report

• scan DRC log

• clocking legality report

Mini case study

Coverage plateau traced to non-scan flops in reset islands; RTL + DFT lint policy fixed root cause.

Debug branches

• Check scan replacement first

• Audit chain legality by domain

• Validate shift/capture clocks

Senior review question

Ask: what evidence proves this DFT decision is safe for production?

Key takeaways

• State metric, lot/corner context, and pattern tag with every claim.

• Treat timing, power, and quality as one signoff problem.

Common pitfalls

• Chasing coverage without legality checks.

• Ignoring test-power side effects of pattern changes.

• Debugging silicon without reproducible tags.

Principal DFT review addendum

Test clocks must safely drive scan shift and at-speed capture modes without violating clock gating, pulse width, or domain assumptions.

Metric: test clock reachability, pulse legality, scan shift/capture violations